Layer 2 switches forward data based on MAC addresses. To do this, they use a MAC address table.
Continue reading
ACSA
[ACSA Training #21] 802.1Q
In the last post, we learned about VLANs. Creating a virtual switch within a single physical switch allows for more efficient broadcasting.
Continue reading
[ACSA Training #20] Virtual LAN
LAN and VLAN LAN (Local Area Network) refers to a group of devices in the same broadcast domain. As shown in the figure, LAN-A and
Continue reading
[ACSA Education #19] Domain
In the last post, we looked at the basic commands of the AOS-CX switch. This time, we will deepen our understanding of Layer 2 concepts.
Continue reading
[ACSA Training #18] ICMP and PoE
I'm adding a new printer to my ICMP network and trying to use it with my laptop. At this point, there is a
Continue reading
[ACSA Training #17] Basic Settings Commands
After purchasing a switch, you need to do a few things before connecting it to your network. You can set the name of the switch or configure the interface.
Continue reading
[ACSA Education #16] Show Command
In today's post, we will look at some very basic things that will help you check your networking equipment along with its general functions.
Continue reading
[ACSA Training #15] AOS-CX CLI Access
There are several ways to connect to an Aruba CX switch. One of them is through the Console port.
Continue reading
[ACSA Training #14] AOS-CX Architecture
I previously discussed the AOS-CX switch when describing the Aruba switch portfolio. Today, I will discuss the AOS-CX operating system and
Continue reading
[ACSA Education #13] Hierarchical Model
When designing and planning a network, we often talk about hierarchical design. In English, we call it the Hierarchical Model. Is this really the case?
Continue reading